update Geometry of Rich detector

• change outer dimension of RICH detector
  • change width and length of RICH
  • change mainframe
    • make shape in top view rectangular
    • make slope on front
      • reuse mainFrame3
      • change mainframe5 to trapezoid form
      • add new mainframe7 which replace some of the mainFrame2
      • cutoff shieldingbox
    • add new mainframe8 in x-direction
    • reduce some mainframes by a length of (2x) thickness from the mainframe to reduce overlapping
      • cutoff a cubic where mainframes cross each other
      • change the length of the pillars
• Rich entrance window
  • change width of the entrance window
  • add 10cm wide and 2cm thick Aluminum flange
  • reduce size of entrance window without flange a bit
• Rich exit window
  • add 10cm wide and 2cm thick Aluminum flange
  • change width to 569cm
  • change hight to 384cm
  • change material of exit window from kapton to Polycarbonat
  • increase thickness to 1cm
• Add Studs to each pillar
  • 10cm x 10cm 0.2cm thick Aluminum
• Add Connections between pillars
  • 6cm x 2.5cm 0.2cm thick Aluminum
• Make beampipe to beampipe tunnel
  • change material to carbon
  • change radius at entrance and exit
  • change pipe thickness to 0.3cm
  • increase the length by 0.5cm
  • change and increase cutoff at middle mirror parts
  • increase hole in sensitivity plane (move subtracted Cone)
  • remove belt types 4 and 5 because of overlap with the beampipe tunnel